ZyXEL Communications ZYWALL USG 20 - Page 31

ZyXEL – ZyWALL USG Support Notes
All contents copyright (c) 2010 ZyXEL Communications Corporation.
31
Step 4. Click CONFIGURATION > VPN > IPSec VPN > VPN Connection to open
the configuration screen to configure the phase-2 rule.
Step 5. Click the Add button to add a rule.
Step 6. To configure the phase-2 rule, user needs to fill in:
- VPN connection name
- VPN gateway selection
- Policy for
 Local network side
 Remote network side
- Phase-2 settings
 Active protocol
 Encapsulation mode
 Encryption algorithm
 Authentication algorithm
 Perfect Forward Secrecy
Step 4. Go back to the previous page to see the newly created IKE rule. Click
the Add button to add a Network policy.
Step 5. To configure the network policy, user needs to fill in:
- Policy name
- The gateway rule it is applied to
- Tunnel policy for
 Local network side
 Remote network side
- Configure the IPSec proposal
 Encapsulation mode
 Active protocol
 Encryption algorithm
 Authentication algorithm
 Perfect Forward Secrecy