ZyWALL 1 Internet Security Gateway
10
Macintosh
Installing TCP/IP Components
TCP/IP should already be installed on Macintosh OS 7 and later systems.
Configuring TCP/IP Properties
1. Click the Apple icon (located in the upper left corner of your screen), select
Control Panels and then TCP/IP.
2. From the "Connect Via" box, select Ethernet.
3. For dynamically assigned settings select Using DHCP Server from the
"Configure" box; for statically (manually) assigned settings see the
following:
a. From the "Configure" box, select Manually.
b. Enter your IP Address in the IP Address box.
c. Enter your subnet mask in the Subnet mask box.
d. Enter the IP address of your ZyWALL in the Router address box.
e. To use a name server, enter its address in the Name server address
box.
4. Close the TCP/IP Control Panel.
5. Click Save if prompted, to save changes to your configuration.
6. Restart your computer, making sure that your ZyWALL is turned on first.
Verifying TCP/IP Properties for the Macintosh
After your Macintosh is configured and has restarted, go back to the TCP/IP
Control Panel. When using DHCP, the default TCP/IP values assigned by the
ZyWALL (shown earlier) are now displayed.
To Next Page
Loading...
