Configuration:
Connect the to the properly set intercom switch output; 2N Security Relay
®
refer to the Configuration Manual. Make sure that one LED at least on the 2N
®
is on or blinking.Security Relay
Press and hold the Reset button for 5 seconds to put the 2N Security Relay
®
device in the programming mode (both the red and green LEDs are blinking).
Activate the intercom switch using the keypad, telephone, etc. The first code
sent from the intercom will be stored in the memory and considered valid. After
code initialisation, the will pass into the operational mode 2N Security Relay
®
(the green LED is blinking).
Caution
In case of resetting the factory default settings on a device with a
version of firmware 2.18 or higher it is necessary to reprogram the
using the instructions above.2N Security Relay
®
Tip
FAQ: 2N Security Relay – what it is and how to use it with 2N IP
®
intercom?
Tip
Video Tutorial: Door 2N IP intercoms – Security Relay
To Next Page
Loading...
