8-12 CHAPTER 8: IP UNICAST ROUTING
Displaying Router
Settings
To display settings for various IP routing components, use the
commands listed in Table 8-5.
Table 8-5 Router Show Commands
Command Description
show ip config {vlan <name> | all} Displays configuration information for one or more VLANs,
including the following:
■ IP address, subnet mask
■ IP forwarding information
■ BOOTP configuration
■ VLAN name, VLANid
■ Global ICMP configuration
■ Global router advertisement configuration
show ip stats {vlan [<name> | all]} Displays IP statistics for the CPU of the Switch.
show iparp {<ipaddress | vlan <name>
| all | permanent}
Displays the IP Address Resolution Protocol (ARP) table. You
can filter the display by IP address, VLAN, or permanent
entries. Each entry displayed includes the following:
■ IP address
■ MAC address
■ Aging timer value
■ VLAN name, VLANid, and port number
■ Flags
show ipfdb {<ipaddress> <netmask> |
vlan <name> | all}
Displays the contents of the IP forwarding database table.
Used for technical support purposes.
show iproute vlan {<name> | all |
permanent | <ipaddress> <netmask>}
Displays the contents of the IP routing table.
show rip {vlan <name> | all} Displays RIP configuration and statistics for one or more
VLANs. Display includes the state for RIP settings, and
interface states. Statistics include the following:
■ Packets transmitted
■ Packets received
■ Bad packets received
■ Bad routes received
■ Number of RIP peers
■ Peer information
(continued)
SW3800.BK Page 12 Tuesday, May 5, 1998 5:20 PM
To Next Page
