7-14 CHAPTER 7: SPANNING TREE PROTOCOL (STP)
Disabling and
Resetting STP
To disable STP or return STP settings to their defaults, use the
commands listed in Table 7-2.
CAUTION: If you ignore warnings and delete an STPD without
removing all of its VLAN members first, those VLANs will also be
deleted.
Table 7-2 STP Disable and Reset Commands
Command Description
delete stpd <stpd_name> Allows you to remove an STPD. An STPD can only be
removed if all VLANs have been deleted from it.
disable stpd [<stpd_name> | all] Allows you to disable the STP mechanism on one or all
STPDs.
disable stpd port <portlist> Allows you to disable STP on one or more ports.
unconfig stpd {<stpd_name> | all} Allows you to restore default STP values to one or all
STPDs.
SW3800.BK Page 14 Tuesday, May 5, 1998 5:20 PM
To Next Page
Loading...
