5-14 CHAPTER 5: VIRTUAL LANS (VLANS)
■ Status for each port
■ Enabled/disabled
■ Tagged/untagged
■ Protocol information
■ IP address
■ STPD information
Sample output from this command is as follows:
3C16910:7 # sh vlan all
VLAN "Default" created by user
Tagging: 802.1Q Tag 1
IP: 192.207.37.214/255.255.255.0
STPD: Domain "s0" is not running spanning tree protocol.
Protocol: Match all unfiltered protocols.
Ports: 23. (Number of active port=1)
Untag: 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20
21 22 23 24 25
VLAN "green" created by user
Tagging: 802.1Q Tag 11
IP: Not configured
STPD: Domain "s0" is not running spanning tree protocol.
Protocol: Match all unfiltered protocols.
Ports: 3. (Number of active port=0)
Untag: 1 2
Tagged: 7
To display protocol information, use the following command:
show protocol {<protocol> | all}
SW3800.BK Page 14 Tuesday, May 5, 1998 5:20 PM
To Next Page
Loading...
