Deleting and Resetting VLANs 5-15
Sample output from this command is as follows:
show protocol all
Protocol Name Type Value
----------------- ---- -----
IP etype 0x0806
etype 0x0800
ipx etype 0x8137
netbios 11c 0xf0f0
decnet etype 0x6004
etype 0x6003
This show command displays protocol information, including the
following:
■ Protocol name
■ List of protocol fields
■ VLANs that use the protocol
Deleting and
Resetting VLANs
To delete a VLAN, or to return VLAN settings to their defaults, use the
commands listed in Table 5-2.
Table 5-2 VLAN Delete and Reset Commands
Command Description
delete vlan <name> Allows you to remove a VLAN.
delete protocol <protocol> Allows you to remove a protocol.
unconfig vlan <name> ipaddress Allows you to remove the IP address.
SW3800.BK Page 15 Tuesday, May 5, 1998 5:20 PM
To Next Page
Loading...
