2 Installing and Connecting the NIC
12
6 Secure the NIC with the screw you removed earlier.
7 Replace the PC cover and plug in the power cord.
Do not turn on the power to the PC. The next step is to connect the NIC to the
network. Go to “Connecting the NIC to the Network” on page 14.
Connecting the Remote Wake-Up Cable
This section describes how to connect the Remote Wake-Up (RWU) cable from the NIC to
the PC motherboard.
Connecting the Remote Wake-Up cable is optional. Connect this cable only if your NIC
supports Remote Wake-Up and you want to use this feature. The following NICs support
Remote Wake-Up:
■ 3C905CX-TX-M
■ 3C905C-TX-M
■ 3C905B-TX
■ 3C905B-TX-M
■ 3C905B-COMBO
■ 3C905B-FX
■ 3C900B-FL
NOTE: If you want to install the Remote Wake-Up cable, go to the next section,
“Connecting the Remote Wake-Up Cable,” to continue the installation. If you do
not want to connect the cable, continue with step 7.
Remove slot cover
Insert NIC
PCI slots
To Next Page
Loading...
