Connecting the Console Cable 35
When you want to use the terminal to configure the switch, follow these
steps to connect a terminal device to your switch using console cables:
1 Plug the DB-9 female connector of the Console cable to the serial port
of the PC or terminal where the switch is to be configured.
2 Connect the RJ-45 connector of the Console cable to the Console port
of the switch.
CAUTION: Pay attention to the mark on the Console port and be sure to
plug the connector to the right port.
If the switch is powered on:
■ First connect the DB-9 connector of the Console cable to the PC
before connecting the RJ-45 connector to the switch.
■ Disconnect the DB-9 connector of the Console cable from the PC after
disconnecting the RJ-45 connector from the switch.
10014914_AB_Switch 4200G.book Page 35 Tuesday, October 2, 2007 12:13 PM
To Next Page
Loading...
