3Com 4200G - Rack-mounting the Switch

22 CHAPTER 2: INSTALLING THE SWITCH
OSTRZEŻENIE: Informacje o zabezpieczeniach. Przed instalacją lub
usunięciem jakichkolwiek elementów z product lub przeprowadzeniem
prac konserwacyjnych należy zapoznać się z informacjami o
bezpieczeństwie zawartymi w Załączniku A niniejszego podręcznika.
Package Contents ■ Switch unit
■ Unit Information Labels
■ Download Notice Flyer
■ Warranty Information
■ Power Cord
■ Console Cable (RJ-45)
■ 2 x Mounting brackets
■ 4 x Screws
■ 4 x Rubber feet
Rack-mounting the
Switch
The Switch 4200G is 1 rack unit (1U) high and will fit in most standard
19-inch racks.
CAUTION: Disconnect all cables from the switch before continuing.
Remove all self adhesive pads from the underside of the switch if they
have been fitted.
To rack-mount your switch:
1 Place the switch the right way up on a hard flat surface, with the front
facing towards you.
2 Locate a mounting bracket over the mounting holes on one side of the
front of the Switch, as shown in Figure 5.
You can also rack mount your switch using the mounting holes at the
rear of the switch.
10014914_AB_Switch 4200G.book Page 22 Tuesday, October 2, 2007 12:13 PM