56 CHAPTER 3: SETTING UP FOR MANAGEMENT
To set a password for the admin user in the CLI, enter the following from
system view:
[S4200G]local-user admin <cr>
[S4200G-luser-admin]password simple xxxxxxxx
(where xxxxxxxx is your chosen password).
Save the configuration in the User View.
For information about the lost password procedure refer to the “Switch
4200G Configuration Guide” available at www.3Com.com.
10014914_AB_Switch 4200G.book Page 56 Tuesday, October 2, 2007 12:13 PM
To Next Page
Loading...
