Switch 4800G PWR 48-Port 11
Switch 4800G PWR
48-Port
Appearance The Switch 4800G PWR 48-Port provides forty-eight auto-sensing
10/100/1000BASE-T Ethernet ports, four 1000Base-X SFP ports, and one console
port on the front panel, and one AC power socket, one RPS port, and two
extended module slots on the rear panel. Figure 5 shows the appearance of the
Switch 4800G PWR 48-Port.
10/100/1000Base-T
port status LED
- Speed Green A 1000 Mbps link is present. When
data is being received or sent, the
LED flashes at a high frequency.
Yellow A 10/100 Mbps link is present. When
data is being received or sent, the
LED flashes at a high frequency.
Flashing yellow (3 Hz) The port fails the POST.
OFF No link is present.
Duplex Green The port works in the full duplex
mode. The LED flashes at a high
frequency when data is being
received or sent.
Yellow The port works in the half duplex
mode. The LED flashes at a high
frequency when data is being
received or sent
Flashing yellow (3 Hz) The port fails the POST.
OFF No link is present.
SFP port status LED
(1000 Mbps)
- The Mode button has no
effect on the LED.
Green A 1000 Mbps link is present. When
data is being received or sent, the
LED flashes at a high frequency.
Flashing yellow (3 Hz) The port fails the POST.
OFF No link is present.
SFP port status LED
(100 Mbps)
- Speed Yellow A 100 Mbps link is present. When
data is being received or sent, the
LED flashes at a high frequency.
Flashing yellow (3 Hz) The port failed the POST.
OFF No link is present.
Duplex Green The port operates in the full duplex
mode. When data is being received
or sent, the LED flashes at a high
frequency.
Flashing yellow (3 Hz) The port fails the POST.
OFF No link is present.
Table 4 LEDs on the front panel of the Switch 4800G 24-Port
LED Mark Status Description
To Next Page
Loading...
