24 CHAPTER 1: PRODUCT OVERVIEW
CX4 Cable You can use a CX4 cable to connect the CX4 port on the rear panel of the Switch
4800G to another CX4 port.
Figure 16 CX4 cable
The following three types of CX4 cables are available:
■ 50 cm (19.7 in.): The connectors at both ends of the cable are bayonet
connectors.
■ 100 cm (39.4 in.): The connectors at both ends of the cable are bayonet
connectors.
■ 300 cm (118.1 in.): The connectors at both ends of the cable are bayonet
connectors.
Tabl e 9 Description of the LED for each extended module slot
LED Mark Status Description
LED for extended
module slot
- This LED is
not affected
by the Mode
button.
Green The port connection is normal.
The LED flashes at a high
frequency when the port is
sending or receiving data.
OFF The port is not connected.
To Next Page
Loading...
