58 CHAPTER 4: INITIAL POWER-ON
■ If you perform no operation or press a key other than Ctrl + B within two
seconds, once the remaining waiting time becomes zero, the system begins to
automatically start up and the following information is displayed:
Auto-booting...
Decompress Image...................................................
...................................................................
...................................................................
...................................................................
...................................................................
...............................................OK!
Starting at 0x80100000...
User interface aux0 is available.
Press ENTER to get started.
Changing the Boot
Mode
By default, the system starts up in fast boot mode. If you want to change the boot
mode to normal, press Ctrl + B within two seconds to enter the Boot Menu
showed below:
BOOT MENU
1. Download application file to flash
2. Select application file to boot
3. Display all files in flash
4. Delete file from flash
5. Modify bootrom password
6. Enter bootrom upgrade menu
7. Skip current configuration file
8. Set bootrom password recovery
9. Set switch startup mode
0. Reboot
Enter your choice(0-9):
Table 15 Description on the fields
Field Description
BOOT MENU Boot menu
Download application file to flash Download the application files to the flash
Select application file to boot Select application files for switch booting
Display all files in flash Display all files in the flash
Delete file from flash Delete files from the flash
Modify bootrom password Modify the password of Boot ROM
Enter bootrom upgrade menu Enter BootROM upgrade menu
Skip current configuration file Skip current configuration files
Set bootrom password recovery Restore the Boot ROM password
Set switch startup mode Set the startup mode of the switch
Reboot Reboot the switch
Enter your choice(0-9): Select your choice 0 to 9
To Next Page
Loading...
