3Com 4800G - Page 60

60 CHAPTER 4: INITIAL POWER-ON
LSP2LTSUA..................................OK!
SDRAM fast selftest........................OK!
Flash fast selftest........................OK!
CPLD selftest..............................OK!
Switch chip selftest.......................OK!
PHY selftest...............................OK!
Subslot 1 (LSP1XP2P) selftest..............OK!
Subslot 2 (LSP1XP2P) selftest..............OK!
Please check leds....................FINISHED!
User interface aux0 is available.
Press ENTER to get started.
The appearance of “Press ENTER to get started” indicates that the automatic
startup of the switch is completed.
Press Enter. The following prompt is displayed:
<SW4800G>
You can configure the switch now.
n
The 3Com Series switches provide abundant command views. For detailed
descriptions about the configuration commands and CLI, refer to 3Com Switch
4800G Family Operation Manual and 3Com Switch 4800G Family Command
Manual.