Local Software Loading 63
2. Set FTP protocol parameter
3. Set XMODEM protocol parameter
0. Return to boot menu
Enter your choice(0-3):
2 Select 3 in the above menu to load the Boot ROM and host software using
XModem protocol. The system displays the following download baud rate setting
menu:
Please select your download baudrate:
1.* 9600
2. 19200
3. 38400
4. 57600
5. 115200
0. Return
Enter your choice (0-5):
3 Select an appropriate download baud rate. For example, if you select 5, the
115200 bps rate is chosen, and the system displays the following information:
Download baudrate is 115200 bps
Please change the terminal’s baudrate to 115200 bps and select XMODE
M protocol
Press enter key when ready
Press Enter after the information above shows that the baud rate has been
changed.
n
If you have chosen 9,600 bps, you do not need to modify the HyperTerminal’s
baud rate, and therefore you can skip Step 4 and 5 below and proceed to Step 6
directly. In this case, the system will not display the above information.
4 Select File > Properties in HyperTerminal, click Configure... in the popup dialog
box, select the bits per second of 115,200 in the console port configuration dialog
box.
To Next Page
Loading...
