3Com 5500-EI PWR - Switch 5500 - Front View Detail; 10 BASE-T; 100 BASE-TX Ports

Switch 5500 — Front View Detail 15
Switch 5500 —
Front View Detail
Figure 1 Switch 5500-SI and Switch 5500-EI 28-Port — front view
Figure 2 Switch 5500-SI and Switch 5500-EI 52-Port - front view
WARNING: RJ-45 Ports. These are shielded RJ-45 data sockets. They cannot
be used as standard traditional telephone sockets, or to connect the unit to a
traditional PBX or public telephone network. Only connect RJ-45 data
connectors, network telephony systems, or network telephones to these
sockets.
Either shielded or unshielded data cables with shielded or unshielded
jacks can be connected to these data sockets.
10BASE-T/
100BASE-TX Ports
The Switch 5500 has 24 or 48 auto-negotiating 10BASE-T/100BASE-TX
ports configured as Auto MDIX (cross-over). These ports automatically
provide the appropriate connection. Alternatively, you can manually set
these ports to 10BASE-T half duplex, 10BASE-T full duplex, 100BASE-TX
half duplex or 100BASE-TX full duplex. The maximum segment length is
100 m (328 ft) over Category 5 twisted pair cable.
Unit LED
Console Port
Mode LED
Power LED
10/100BASE-TX Ports
Port Status LEDs
1000BASE-X Ports
RPS LED
Unit LED
Console Port
Mode LED
RPS LED
10/100BASE-TX Ports
Port Status LEDs
1000BASE-X Ports
PWR LED
DUA1715-0AAA02.book Page 15 Wednesday, March 23, 2005 11:17 AM