80 CLI Reference Guide
Console Password
The Console Password command changes the user’s password
Syntax
[Console] Password [password]
Parameters
• password – the new password to be assigned.
Default Configuration
This command has no default configuration.
User Guidelines
Entering the password command without supplying a new password will display the
current password. To remove the password it is necessary to restore the unit back to
factory defaults. See the System Restore Command.
Example
The following displays the list presented for the Console password command:
>console
Console>password admin
Console>password
Password: admin
Console>
IP Setup
The IP Setup command allows the user to display the IP address settings or to define a
manual IP address on the device.
Syntax
[IP] setup
[<ipaddress> ][<ipmask> ][<ipgateway>] [<vid>]
Parameters
• ipaddress – IP address to assign
• ipmask – IP subnet mask to assign
• ipgateway – IP gateway to assign
• vid – VLAN ID. This value should only be set to 1 if specified
Default Configuration
To Next Page
Loading...
