6
6. Configuring the Access Point
The CD shipped with your Access Point includes software to help you setup and administer the
Access
Point. Perform the following steps to configure your Access Point for the first time:
1 Insert the 3Com Access Point CD into your PC's CD-ROM drive. Your PC must be on your
wired network to set up the Access
Point.
2 Run the Set-up Wizard.
If the Set-up Wizard does not start automatically, launch the program by typing
autorun.exe.
3 Follow the Set-up Wizard’s instructions on the screen.
4 (Optional) Change the default settings.
The Access Point is preconfigured with a set of common default parameters. However, if you
would like to change these settings, the Access
Point can be configured through your web
browser with the Web-based interface.
The default wireless settings for the Access Point are:
7. Troubleshooting
For troubleshooting information please refer to your User's Guide or visit 3Com’s World Wide
Web site:
http://www.3com.com.
Password: admin
SSID: 3Com
Channel: 11-2.462GHz
To Next Page
Loading...
