Default Settings
17
Console Port The console port allows you to connect a terminal and perform remote or
local out-of-band management. The console port uses a standard null
modem cable and is set to 19,200 kbps, 8 data bits, no parity and 1 stop
bit.
Expansion Module
Slot
You can use this slot to install an Expansion Module. Contact your
supplier for further information.
WARNING:
When an Expansion Module is not installed, ensure the
blanking plate is fitted by tightening all screws with a suitable tool.
Default Settings
Ta b le 6 shows the default settings for the Switch 4950. If you initialize
one of the Switch units, it is returned to these defaults.
Ta b l e 6 Default Settings
Feature Switch 4950
Port Status
Enabled
Port Speed
Auto-negotiated
Duplex Mode
Auto-negotiated
Flow Control
Auto-negotiated
Broadcast Storm Control
Enabled
High threshold: 3000 broadcast frames per second —
Notify and filter
Low threshold: 1500 broadcast frames per second —
Notify and unfilter
Virtual LANs (VLANs)
All ports belong to the untagged Default VLAN
(VLAN 1)
Multicast Filtering
IGMP filtering enabled
Spanning Tree Protocol
Disabled
Smart Auto-sensing
Enabled
IP Address
0.0.0.0
To Next Page
Loading...
