Setting Up Web Interface Management
37
6 If you have logged on correctly, the top-level menu of the command line
interface for the Switch you wish to manage is displayed.
Setting Up Web
Interface
Management
This section describes how you can set up web interface management
over the network.
Pre-requisites
■
Ensure you have already connected via the console port and set up the
Switch with IP information as described in “
Initial Switch Setup” on
page 31
and you have an Ethernet connection to the Switch.
■
A suitable Web browser.
Choosing a Browser
To display the web interface correctly, use one of the following Web
browsers:
■
Netscape Navigator
®
version 4.5, 4.6, or 4.7.
■
Microsoft Internet Explorer version 4.0, 5.0, or 5.5.
For the browser to operate the web interface correctly, JavaScript™ and
Cascading Style Sheets must be enabled on your browser. These features
are enabled on a browser by default. You will only need to enable them if
you have changed your browser settings.
Web Management
Over the Network
To manage a Switch using the web interface over an IP network:
1 Check that you have the IP protocol correctly installed on your
management workstation. You can check this by trying to browse the
World Wide Web. If you can browse, the IP protocol is installed.
2 Check you can communicate with the Switch by entering a ping
command at the DOS prompt in the following format:
c:\ ping xxx.xxx.xxx.xxx
(where xxx.xxx.xxx.xxx is the IP address of the Switch)
If you get an error message, check that your IP information has been
entered correctly.
3 Open your web browser and enter the IP address of the Switch that you
wish to manage in the URL locator. Use a valid user name and password
to log on to the Switch. The web interface for the Switch is displayed.
To Next Page
Loading...
