Upgrading from the Command Line Interface 59
7 Download the boot ROM file by entering the following command:
get s3r01_15.btm
If you receive the “202 Command PASV not implemented” message when issuing
a command within FTP, enter the
undo pas command. The “% Passive is
off” message displays. Then issue the command
get s3r01_15.btm again.
Passive mode is the default mode for the FTP client on the switch.
8 Enter quit or bye to exit.
Example: The following example updates the switch’s software using FTP. The
FTP server’s IP address is 10.0.1.100. The application to be loaded is
s3q05_01_00s56.app and the boot ROM file is s3r01_15.btm.
<4210>ping 10.0.1.100
PING 10.0.1.100: 56 data bytes, press CTRL_C to break
Reply from 10.0.1.100: bytes=56 Sequence=1 ttl=128 time=3 ms
Reply from 10.0.1.100: etc...
--- 10.0.1.100 ping statistics ---
5 packet(s) transmitted
5 packet(s) received
0.00% packet loss
round-trip min/avg/max = 2/2/5 ms
<4210>ftp 10.0.1.100
Trying 10.0.1.100 ...
Press CTRL+K to abort
Connected to 10.0.1.100.
220 3Com FTP Server Version 1.1
User(10.0.1.100:(none)) :(FTP User ID)
331 User name ok, need password
Password:(password for the FTP user ID)
230 User logged in
[ftp] bin
200 Type set to I.
[ftp]get s3q05_01_00s56.app
202 Command PASV not implemented
FTP: Error Writing Local File(Screen).
[ftp]undo pas
FTP: passive is off
[ftp]get s3q05_01_00s56.app
200 PORT command successful.
150 File status OK ; about to open data connection
....(etc)....
226 File transfer successful.
FTP: 5286666 byte(s) received in 127.170 second(s), 41.00K
byte(s)/sec.
[ftp]get s3r01_15.btm
200 PORT command successful.
150 File status OK ; about to open data connection
..............226 File transfer successful.
FTP: 377424 byte(s) received in 15.597 second(s), 24.00K
byte(s)/sec.
To Next Page
Loading...
Need help?
General
