3Com Switch 4210 Series User Manual

Introduction to the Switch 4210 Family PWR Switches 9
n
If the left screw hole above the security slot is used, the security slot cannot be
used.
Power system
Switch 4210s 9-port PWR support AC input.
■ Rate voltage range: 100 VAC to 240 VAC, 50 Hz/60 Hz
■ Input voltage range: 90 VAC to 264 VAC, 47 HZ to 63 Hz
Cooling system
Switch 4210s 9-port PWR each run two fans for heat dissipation.
Switch 4210 PWR
18-port
Front panel
Switch 4210s 18-port PWR each provide sixteen 10/100Base-TX autosensing
Ethernet ports, two 10/100/1000Base-T Ethernet ports, two 100/1000Base SFP
ports, and one Console port. Each SFP port and the corresponding
10/100/1000BASE-T Ethernet port form a Combo port. For each Combo port,
either the SFP port or the corresponding 10/100/1000BASE-T Ethernet port can be
used at a time.
Figure 5 shows the front panel of an Switch 4210 18-port PWR.
Figure 5 Front panel of an Switch 4210 18-port PWR
(1) 10/100Base-TX autosensing Ethernet port status LED
(2) Link LED for Combo port (3) Console port
(4) Power LED (PWR) (5) A/L LED
(6) D/S LED (7) Mode button
(8) Active LED for Combo port
(1) (2) (3) (4)
(5)(6)(7)(8)

3Com Switch 4210 Series Specifications

General

Model	3Com Switch 4210 Series
Layer	Layer 2
Management	CLI
VLAN Support	Yes
QoS	Yes
Jumbo Frame Support	Yes
Power Supply	Internal
Operating Temperature	0°C to 40°C
Relative Humidity	10% to 90% non-condensing
Uplink Ports	4 SFP ports (on 24-port model), 4 SFP ports (on 48-port model)
Dimensions (W x D x H)	440 x 260 x 44 mm (24-port model), 440 x 260 x 44 mm (48-port model)