Why is the talk volume low on my 3M C1060 headset?
If you're experiencing low talk volume on a single 3M Intercom System headset, call for authorized service, because the holes in front of the microphone may be plugged with dirt or grease. The operator may not be positioning the microphone correctly (refer to Operating Guide). The headset itself could also be defective and require professional attention.
Why won't my 3M Intercom System headsets go into standby?
If all headsets on your 3M Intercom System do not go into Standby (silence) when the vehicle leaves the menu sign, and a pulse (air switch) type of vehicle detector is used, press the Page switch to silence the menu microphone. If there is a large metal object near the loop in the driveway (if a loop is used), remove the object. If the loop detector is 'locked up,' unplug it from the AC outlet and plug it back in to reset the detector. Finally, the vehicle detector may be defective and require authorized service.
What to do if no lights come on when charging a 3M C1060 Intercom System battery?
If no lights come on when a battery is inserted into the 3M Intercom System charger, clean the contacts on both the battery and the charger with a water moistened swab. Also, verify that the charger is properly connected to a 'live' outlet. If the issue persists, try using a known good battery to rule out a defective battery. If the problem continues, the charger itself may be defective, and you should call for authorized service.
Why is there no vehicle alert tone in my 3M Intercom System headset?
If the vehicle alert tone is not heard in the 3M Intercom System headset, ensure the vehicle detector is receiving power by plugging it into a power outlet or replacing the detector fuse. If the detector seems 'locked up', remove power to it for a few seconds to reset it. Also, check that the base station alert tone volume is not set too low and adjust it accordingly.
Why is there no talk or listen from the menu sign on my 3M C1060's backup wired intercom?
If you experience no talk or listen from the menu sign when using the backup wired intercom on your 3M Intercom System, but the C1060 system works OK, ensure that the base station is turned OFF. Also, check that the backup intercom has power by turning it on or plugging in its power transformer. Make sure the volume controls are turned up on the backup intercom. If problems persist, the backup intercom or its wiring may be defective, and you should call for authorized service.
How to fix static on a single 3M C1060 Intercom System headset?
If a single 3M Intercom System headset hears static, first, reprogram the headset with the programming station to ensure it's on the same channel as the base station. If the issue persists, try programming other headsets. If they won’t program, replace the programming station. If other headsets program OK, the single headset may be defective and needs repair.
What to do if a 3M C1060 headset is dead?
If a single 3M Intercom System headset is dead and producing no static, first ensure that the headset is turned on by pressing the ON button. If it still doesn't work, the battery may be discharged; replace it with a fully charged one. If the problem persists, the headset may be defective, and you should call for authorized service.
Why do all 3M Intercom System headsets only produce static?
If all headsets are only producing static, first, ensure the base station is powered ON and the power transformer is correctly plugged into both the wall outlet and the base station. If the red power light doesn't illuminate, verify power at the wall outlet. It is also possible that the base station and headsets are not programmed to the same channel, in which case you should reprogram the headsets using the programming cable. If the issue persists, the base station may be defective, and you should call for authorized service.
How to troubleshoot static on a single 3M C1060 headset?
General| Brand | 3M |
|---|---|
| Model | C1060 |
| Category | Intercom System |
| Language | English |
To Next Page
