12
Programming the Headsets for Cross–Lane Operation
Follow the steps below to program the headsets for Cross–Lane operation, and disable the Talk—Lock function. It does not
matter which base station is used to program the headsets. By pressing T1, the headset will communicate with the lane 1 base
station; by pressing T2, the headset will communicate with lane 2 base station.
1. Disable the Talk Lock function:
Talk–Lock is a toggle function that must be checked first to see if it is enabled or disabled. If the Talk LED on the base
station lights when the L button is pressed, Talk–Lock is enabled.
• To disable Talk–Lock, turn the headset OFF, press and hold the L button while pressing ON for 5 seconds. You will
hear a series of beeps indicating that Talk–Lock is off.
• Recheck the Talk–Lock function by pressing the L (talk-lock) button. The Talk LED on the base station should not
light.
2. Programming the headsets for Cross–Lane Operation:
a. Start with the headset OFF. Then, hold down the T1 and T2 buttons while pressing ON for 5 seconds. You will hear
a series of beeps indicating that the headset has been programmed.
b. Verify that the headsets are properly programmed for Cross–Lane operation as follows:
(1)
Press T1 and verify that the Talk LED lights on the lane 1 base station and does not light on the lane 2 base
station.
(2)
Press T2 and verify that the Talk LED lights on the lane 2 base station and does not light on the lane 1 base
station.
c. To remove the Cross–Lane function and return the headsets to the normal (single lane) operating mode, first turn the
headset OFF, and then do one of the following operations:
– For lane 1 operation only, hold down T1 while pressing ON for 5 seconds. You will hear a series of beeps
indicating that Cross–Lane function is no longer active. Reprogram the headsets from the lane 1 base station
if you want to communicate with lane 1.
– For lane 2 operation only, hold down T2 while pressing ON for 5 seconds. You will hear a series of beeps
indicating that Cross–Lane function is no longer active. Reprogram the headsets from the lane 2 base station
if you want to communicate with lane 2.
Operation
Cross–Lane Module OFF:
Vehicle detector alerts
The operator will only hear the vehicle detector alert from the menu sign with which he or she last talked. Vehicles at
menu sign 1 will be heard as a single repeating alert. Vehicles at menu sign 2 will be heard as a double repeating
alert.
Answering customers
Pressing T1 will only allow communications with the lane 1 customer. Pressing T2 will only allow communication
with the lane 2 customer.
Paging function
Pressing the P (Page) button will communicate using the base station last communicated with (via T1 or T2).
Headsets programmed for the last used base station will receive the page.
To Next Page
Loading...
Need help?
General
