2222
9. Press power [1] to turn on the receiver.
10. Press Locate [5].
11. Press Cable/Pipe [SK].
12. Set the Frequency and mode of the receiver.
Press Freq [SK]
Select the same frequency on the receiver as the transmitter by
pressing Active [SK Toggle].
Press Locate [5] to save the setting and return to locate mode.
Press Mode [SK Toggle] until DirPk is displayed.
13. Stand away from the suspected target path and adjust the Gain Down
[4] until the bar graph opens completely.
14. Walk in a wide circle with your back toward the transmitter (about 10-
15 feet away).
* Watch the receiver screen and listen to the signal. Take note of where
the receiver detects the strongest signals.
* The bar graph will close when the unit detects a signal, and the
arrows will reverse.
* Adjust the gain down [4] if the bar graph closes completely.
* The numbers on the display will change with the signal strength
(smaller, as you walk away from the target path; larger, as you
approach the target path).
* Make a complete circle around the transmitter. Return to each point
in the circle that the receiver detected.
To Next Page
Loading...
Need help?
General
