40
Select type of marker to be written Marker [SK Toggle].
Hold the receiver directly over the top of the marker. The receiver should be
within 12 inches (30 cm) of the marker.
Press Start Write [SK].
The receiver will ask if the user wants to permanently lock the marker data.
Select Yes [SK] or No [SK]. The receiver will write the data to the marker.
Note: Once the marker data has been locked the information contained on
the marker is PERMANENT.
Modifying Marker Data to be Programmed
To alter the information to be programmed into the marker
Press Menu [6] + Write Mode [SK].
Select a template from the list on the screen, to program into the marker by
pressing the up/down arrows [SK] to highlight the preferred template. ‘Last
Written’ is the most recent data that was programmed to a marker by the
receiver.
Press View/Edit [SK].
To Next Page
Loading...
Need help?
General
