42
Press Select [SK] to enter the alphanumeric character.
Entry will appear at the top of the screen.
Press OK [5] when entry is complete.
If Show All is selected, the following screen will appear.
Select a common term from the list by pressing the up/down arrows [SK].
Press OK [5]. The modification will automatically populate the marker
template.
Reading iD Markers
The operator can retrieve the data from the iD marker by pressing Read
[SK] (on the locate screen or the depth screen).
The receiver tip should be lowered to the ground to reach maximum read depth.
If more than one 3M
™
EMS iD Marker of the same utility is detected, the
receiver will read the first marker and display the data from the marker.
The fourth yellow command key will be labeled “Read Next”. Press this key
to extract the data from the other marker.
All the information retrieved from the marker, including the date and time
read, is saved into the ‘Read History’ file of the receiver. If a hand-held GPS
unit is used in conjunction with the receiver, coordinates can be saved into the
Read History. (See Reviewing Marker History)
To Next Page
Loading...
Need help?
General
