14
Power ON/OFF
Turning On The Power
WARNING • When the power is ON, a strong light is emitted. Do not look into the
lens or vents of the projector.
• Turn the power on/off in right order. Please power on the projector before
the connected devices. Power off the projector after the connected devices.
NOTE
1
Make sure that the power cord is
firmly and correctly connected to the
projector and outlet.
2
Set the power switch to [ | ] (ON).
3
Press the button of the projector or
the remote control.
The projector lamp will light up and the power
indicator will begin blinking green.
According to a setup, the projector lamp may light
up and the power indicator may begin blinking
green, without pressing this button.
When the power is completely on, the indicator will
stop blinking and light green.
The power indicator will light orange.
Power switch (ON position)
VIDEO
ASPECT
VOLUME
STANBY/ON
MAGNIFY
AUTO BLANK
RGB SEARCH
ON
(STANDBY/ON) button
Power switch
(on/off)button
power
indicator
01S10En03.9.245:07PMページ14
To Next Page
Loading...
Need help?
General
