3M H10 - Multifunctional Settings: PICTURE-2 Menu; PICTURE-2 Menu Settings

26
PICTURE - 2 Menu
With the PICTURE - 2 menu, the items shown in the table below
can be performed.
Perform each operation in accordance with the instructions in the
table below.
MENU
MAIN
PICTURE-1
PICTURE-2
INPUT
AUTO
SCREEN
OPTION
V POSITION
H POSITION
H PHASE
H SIZE
OVER SCAN
RESET
20
142
31
1344
95
: SELECT
Item Description
V POSITION
Adjust the Vertical Position: Up ⇔ Down
• This item can be selected only at a RGB input.
H POSITION
Adjust the Horizontal Position: Left ⇔ Right
• This item can be selected only at a RGB input.
H PHASE
Adjust the Horizontal Phase (to eliminate flicker) :
Right ⇔ Left
• This item can be selected only at a RGB input or a COMPONENT VIDEO
input.
H SIZE
Adjust the Horizontal Size: Large ⇔ Small
• When this adjustment is excessive, the picture may not be displayed
correctly. In such a case, please press the RESET button during selection of
this item to reset the H SIZE.
• This item can be selected only at a RGB input.
OVER SCAN
Adjust the Over-scan Ratio:
Large ⇔ Small
• This item can be selected only at a VIDEO input, a S-VIDEO input or a
COMPONENT VIDEO input.
• When this adjustment is too large, a certain degradation may appear at the
frame area of the picture. In such a case, please adjust small.
RESET
Reset the PICTURE-2 Menu Items:
Selecting the EXECUTE performs this function.
EXECUTE CANCEL
• The items of the PICTURE-2 menu are collectively returned to the initial
setting. Note that the H PHASE item is not reset.
Multifunctional Settings (continued)
⇒
01S10En03.9.245:07PMページ26