3M Matic 700r - Machine Specifications; Power, Operation, and Conditions

7
(Specifications continued on next page)
1. Power Requirements:
Electrical – 115 VAC, 60 Hz, 3.8 A (440 watts)
Pneumatic – 5 bar gauge pressure [70 PSIG]
110 litre/min @ 21° C, 1.01 bar [3.75 SCFM] at 15 boxes per minute
A pressure regulator is included
The machine is equipped with two 1/6 HP gearmotors and comes with an 2.4 m [eight foot] standard
neoprene covered power cord and a grounded plug. Contact your 3M Representative for power requirements
not listed above.
2. Operating Rate:
Up to 15 boxes per minute. Actual production rate is dependent on box size, box size mix, and operator
dexterity.
Box drive belt speed approximately 0.4 m/s [78 FPM]
3. Operating Conditions:
Use in dry, relatively clean environments at 4° to 50° C [40° to 120° F] with clean, dry, boxes.
Specifications
4. Tape:
Scotch
TM
brand pressure-sensitive film box sealing tapes.
5. Tape Width:
36 mm or 1 1/2 inch minimum to 50 mm [2 inch] maximum
6. Tape Roll Diameter:
Up to 405 mm [16 inch] maximum on a 76.2 mm [3 inch] diameter core.
(Accommodates all system roll lengths of Scotch
TM
brand film tapes.)
7. Tape Application Leg Length – Standard:
70 mm ± 6 mm [2 3/4 inch ±1/4 inch]
Tape Application Leg Length – Optional:
(See "Special Set-Up Procedure", page 29)
50 mm ± 6 mm [2 inch ±1/4 inch]
Note – Machine should not be washed down or subjected to conditions causing moisture condensation
on components.