3M
™
Pocket Projector 180
© 2010 3M. All Rights Reserved.
11
English
Getting Started
Install Battery
The 3M projector comes with a rechargeable battery. The battery should be fully
charged before using the projector with the battery.
To install the battery: point the contacts on the battery toward the contacts on the
projector, insert the end farthest from the battery latch first, then push down until
the battery clicks into place.
Remove Battery
To remove the battery: slide the battery latch away from the battery and then lift the
battery out, starting at the end closest to the latch.
Important Note: Use only the 3M-specified battery: 78-6972-0026-5
To Next Page
Loading...
Need help?
General
