To Next Page

To Previous Page

™

Pocket Projector 180

English

Charge the Battery

The 3M 180 rechargeable battery gives you up to two hours of battery life. When

the battery needs to be charged, the status indicator will ﬂash red or the low battery

message will display. The battery should be fully charged before using the 3M

180projector.

Charge the battery by connecting the 3M 180 power adapter to theprojector. When

the power adapter is connected, the battery status icon which normally displays is

replaced by the power adapter icon.

1 Turn the projector power off.

2 Connect the power adapter to the projector’s DC input.

3 Connect the other end of the power adapter into the electrical outlet.

4 The status indicator will change to amber while the battery is charging.

5 Allow three hours to fully charge the battery. When charging is complete, the

status indicator will turn off.

110–240 VAC

50/60 Hz

Note: The battery status will not appear when the power adapter is connected

to the projector. The power adapter icon will appear instead.

3M MP180 User Manual

Other manuals for 3M MP180