33
e-SHOT(Still Image Transfer) Display
e-SHOT (Still Image Transfer) Settings (Continued)
When the authentication setting is enabled, the following settings are required.
6) Click [Security Settings] on the main menu.
7) Select [Network Control] and enter the desired authentication password. *
see Note1
8) Click the [Apply] button to save the settings. * see Note2
• The Authentication Password will be the same for [Network Control
Port1 (Port: 23)], [Network Control Port2 (Port: 9715)], and [Image Transfer
Port (Port: 9716)].
NOTE1
• The new conguration settings are activated after restarting the
network. Restart the network connection when any conguration settings are
changed. The network connection can be restarted using [Network Restart] on
the main menu.
NOTE2
e-SHOT (Still Image Transfer) Transmission
e-SHOT transmission requires an exclusive application for your PC. Please visit
www.3m.com/meetings to obtain the application and software update. Refer to the
manual for the application for instructions.
3M™ Digital Projector X90
© 3M 2007. All Rights Reserved.
To Next Page
Loading...
