3M X90 - E-Shot(Still Image Transfer) Display

To Next Page

To Previous Page

e-SHOT (Still Image Transfer) Display

The projector can display a still image that is transferred via the network.

Communication Port

The following port is used for e-SHOT.

TCP #9716

(9)

e-SHOT (Still Image Transfer) Settings

Congure the following items from a web browser when e-SHOT is used.

Example: If the IP address of the projector is set to 192.168.1.10:

• e-SHOT is not available via communication ports which are used for

the command control (TCP #23 and TCP #9715).

NOTE

1) Enter

[https://192.168.1.10] into the address bar of the web browser.

2) Enter the Administrator ID and Password and

click [Logon].

3) Click [Port settings] on the main menu.

4) Click the [Enable] check box to open the

[Image Transfer Port (Port: 9716)]. Click the

[Enable] check box for the [Authentication]

setting when authentication is required,

otherwise clear the check box.

5) Click the [Apply] button to save the settings.

3M™ Digital Projector X90

Other manuals for 3M X90