3M X90 - Network Settings

8
Settings
Network Settings
Displays and congures network settings.
Click the [Apply] button to save the settings.
• The new conguration settings are activated after restarting the
network connection. When the conguration settings are changed, you must
restart the network connection. You can restart the network connection by
clicking [Network Restart] on the main menu.
• If you connect the projector to an existing network, consult a network
administrator before setting server addresses.
NOTE
Item Description
IP Conguration Congures network settings.
DHCP ON Enables DHCP.
DHCP OFF Disables DHCP.
IP Address Congures the IP address when DHCP is disabled.
Subnet Mask Congures the Subnet Mask when DHCP is disabled.
Default Gateway Congures the Default Gateway when DHCP is disabled.
Projector Name Congures the Projector name.
SysLocation Congures the location to be referred to when using SNMP.
SysContact
Congures the contact information to be referred to when
using SNMP.
3M™ Digital Projector X90
© 3M 2007. All Rights Reserved.