3M X90 - Port Settings

9
Settings
Port Settings
Displays and congures communication port settings.
Click the [Apply] button to save the settings.
• The new conguration settings are activated after restarting the
network connection. The network connection must be restarted when the
conguration settings are changed. The network connection can be restarted
using [Network Restart] on the main menu.dresses.
NOTE
Item Description
Network Control Port1
(Port:23)
Congures command control port 1 (Port:23).
Port open Click the [Enable] check box to use port 23.
Authentication
Click the [Enable] check box when authentication is required
for this port.
Network Control Port2
(Port:9715)
Congures command control port 2 (Port:9715).
Port open Click the [Enable] check box to use port 9715.
Authentication
Click the [Enable] check box when authentication is required
for this port.
Image Transfer Port
(Port:9716)
Congures the image transfer port (Port:9716).
Port open Click the [Enable] check box to use port 9716.
Authentication
Click the [Enable] check box when authentication is required
for this port.
SNMP Port Congures the SNMP port.
Port open Click the [Enable] check box to use SNMP.
Trap address Congures the destination of the SNMP Trap in IP format.
SMTP Port Congures the SMTP port.
Port open Click the [Enable] check box to use the e-mail function.
3M™ Digital Projector X90
© 3M 2007. All Rights Reserved.