3M X90 - Page 35

35
Command Control via the Network
Command Control Settings (Continued)
When the authentication setting is enabled, the following settings are required.
(20)
7) Click
[Security Settings] on the main menu.
8) Click [Network Control] and enter the desired authentication password. * See
Note1.
9) Click the [Apply] button to save the settings. * See Note2.
• The Authentication Password will be the same for [Network Control
Port1 (Port: 23)], [Network Control Port2 (Port: 9715)], and [Image Transfer
Port (Port: 9716)].
NOTE1
• The new conguration settings are activated after restarting the
network. Restart the network when any conguration settings are changed.
The network connection can be restarted using [Network Restart] on the main
menu.
NOTE2
3M™ Digital Projector X90
© 3M 2007. All Rights Reserved.