12
2. Equipment connection and network setting
2.3 Manual network connection setting – In case of wired LAN - (Continued)
5) When more than 2 usable network devices exist, make only one device “valid”
that you want to use and the rest of devices “invalid”. (In this case, “Local Area
Connection” is selected.)
6) Open “Local Area Connection Properties” window you use for network device.
(Fig. 2.3.2.c)
Fig. 2.3.2.c “Local Area Connection Properties” window
7) Set used protocol as “TCP/IP” and open “Internet Protocol (TCP/IP) Properties”
window.
Fig. 2.3.2.d “Internet Protocol (TCP/IP) Properties” window
8) Set IP address, subnet mask and default gateway for PC.
To Next Page
Loading...
