3M X90w - Page 24

24
Click the [Apply] button to save the settings.
• The new conguration settings are activated after restarting the
network connection. When the conguration settings are changed, you must
restart the network connection. You can restart the network connection by
clicking [Network Restart] on the main menu.
• If you connect the projector to an existing network, consult a network
administrator before setting server addresses.
NOTE
2. Equipment connection and network setting
2.5.2 Network Settings (Continued)
WEP Key
Input WEP key, which has same length dened by WEP.
When "64bit" or "128bit" is selected, input 10 characters or
26 characters respectively. Only numbers from "0" to "9" and
alphabets from "a" to "f" can be used.
WPA Passphrase
Input WPA Passphrase. Available number of input characters
is 8 to 63. Only alphabets, numbers and following symbols
can be used.
!"#$%&'()*+,-./[¥]^_`{|}~
SSID
Set SSID. Maximum number of input characters is 32. Only
alphabets, numbers and following symbols can be used.
!"#$%&'()*+,-./[¥]^_`{|}~
Item Description
Wireless Mode Select "AD-HOC" or "Infrastructure".
CH
(Communication
channel)
Select using channel between "1" and "11".
Speed
(Communication speed)
Select communication speed.
Encryption Select data encryption method.
• Depending on the country where you are
the channels may vary. In addition, depending on the
country or region where you are may be required to use
a wireless LAN card that conrm to the standards in the
respective country or region.
NOTE
2.5 Conguring and controlling the projector via a web browser (Continued)