76
Command Control Settings (Continued)
When the authentication setting is enabled, the following settings are required.
(36)
7) Click [Security Settings] on the main menu.
8) Click [Network Control] and enter the desired authentication password. * See
NOTE1.
9) Click the [Apply] button to save the settings. * See NOTE2.
• The Authentication Password will be the same for [Network Control
Port1 (Port: 23)], [Network Control Port2 (Port: 9715)], and [Image Transfer
Port (Port: 9716)].
NOTE1
• The new conguration settings are activated after restarting the
network. Restart the network when any conguration settings are changed.
The network connection can be restarted using [Network Restart] on the main
menu.
NOTE2
4. Utilize projector – Advanced -
To Next Page
Loading...
