17
W
ith a few simple tools, you’ll be ready for just
about any kind of basic motor service. To make
your job easier when installing or servicing a
pool or spa motor, make sure that you have these tools
in your toolbox before you begin working...
• Standard screwdriver
• Wide blade screwdriver
•
1
⁄
2
” open end wrench
• Rubber mallet
• Clamp-on ammeter/voltmeter
• Ammeter
•
5
⁄
16
” nut driver
• Needle-nose pliers
• Tape for marking
A
.O. Smith pool and spa pump motors are built
tough, to run day after day without being serviced.
When service is necessary, serviceable parts usu-
ally can be accessed quite easily. For example, capaci-
tors are externally mounted, and single-phase motors
have screw-type connectors for quick reconnection in
the field.
Water leaks from pump
seals or pipe joints should
be repaired to prevent failure of bearings and insulation.
DO NOT splash or spray the motor. Mount the motor
away from low spots and damp areas, and take mea-
sures to protect it from windblown rain.
MOISTURE
MAINTENANCE
TOOLS
To Next Page
Loading...
