a2b Ferber - Further Maintenance (Every 2,000 km)

42
Further maintenance: every 2,000 km
No. Step inspection 1 2 3 4 5 6
Component assembly: Frame-handlebars-stem-saddle post-saddle • Check components for cracks and replace, if necessary • Check screws on handlebars/stem/saddle • Clean & lubricate saddle post pipe Front fork • Completely clean suspension fork, espec. sliding surfaces of the
standpipes
• Check standpipes for damage, replace, if necessary Rear wheel slot • Clean TMM4 sensor using air, without demounting it • Check firm fit & state of the sensor plate • Check axle screws for firm fit Component assembly: Crank - inside bearing-pedal • Clean crank & pedal / lubricate pedal axle • Check sprocket for wear, replace, if necessary • Check crank and pedal fastening for firm fit • Check play of bottom bracket bearing, replace, if necessary • Demount bottom bracket bearing, clean & lubricate casing & thread Component assembly: Chain-cassette-sprocket • Clean all parts. • Check all screws for firm fit • Check components for wear, replace, if necessary • Clean & lubricate chain Component assembly: Wheels-rims-tyres • Clean parts • Check tyres for damage and tread • Adjust tyre air pressure • Check front and rear wheel rim for lateral and radial run-out,
adjust, if necessary
• Check spoke tension, adjust, if necessary • Check functioning & bearing play of front wheel hub. • Demount, clean and lubricate hub
X X X X X X X X X X X X X X X X X X X X X X X X