74
Owner’s manual
No. Step inspection
7
8
9
10
11
Date
Signature / stamp of the A2B specialist workshop
Steering head
• Check bearing play of steering head and adjust or replace,
if necessary
Component assembly: Derailleur system
• Clean and lubricate derailleur mechanism and derailleur.
• Check derailleur system cord and outer shells for state and function,
replace, if necessary
• Check derailleur mechanism adjustment, adjust, if necessary
• Check all screws on the derailleur mechanism/derailleur for firm fit
Component assembly: Brake system
• Clean brake bosses.
• Check brake pads, replace, if necessary
• Check brake pressure, refill brake oil, if necessary
• Check brake system for tightness.
• Check brake system screws for firm fit
• Check brake function and efficiency
Guard plates-luggage rack-side stand-lighting system
• Tighten all screws
• Check lighting system for functioning & setting, adjust, if necessary
Component assembly: electrical drive system & lock
• Check lines for proper fastening, breakings, chafing, bends, replace,
if necessary
• Check plug contacts for corrosion and scaling, clean or replace,
if necessary
• Check cable joints for correct connection
• Check display for functioning & error codes
• Run current software update
• Check battery state and charge
• Check alignment & state of the battery slide rails, adjust/replace,
if necessary
• Check locking cylinder on battery slot for functioning, clean and
lubricate
• Check brake switch/motor stop switch for functioning
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
To Next Page
Loading...
