AAI N2201SS - Scan Function

8
2. Scan Function
Press M key under Single Point Measurement mode, it will switch to the
Scan Function interface.
Five type parameters of Scan Function can be modified.
Scan Parameters Types：There are five scanning parameters including S11,
VSWR,| Z|, R, X,
Scaling: Scaling shows the Y-axis, and can be adjusted based on the
measured value
Mark Points Frequency: Scan mark points frequency of the graphic
Start Frequency: Start frequency of the scan
Ending Frequency: Ending frequency of the scan
Selecting Mode and Adjusting Mode are two different modes as adjusting
the parameter, you can press OK key to switch between them.
Under Selecting Mode, press Right/Left key or turn the Knob to select the
parameter you need to adjust, once selected, the parameter will turn red
(The original color of Start Frequency , Ending Frequency and Mark Points
Frequency turn to red indicates the parameter is selected) or there will
show a red box (Scan Parameters Types or Scaling). After press OK key, it