Function Description
There are four basic operational interfaces including Single Point
Measurement, Scan Function, Power meter Measurement ， System
Information and Calibration.
The default interface after power-on is Single Point Measurement.
1. Single Point Measurement
This interface is used for measuring the fixed frequency point.
Only frequency parameters can be adjusted in this interface. Press Right
or Left key to select the digit you need to adjust, once selected, the digit
will turn red, and the digit can be modified by turning the knob. After
adjusting the frequency, the measuring result will automatically update.
Note: How to adjust values in other place of this product is the same as
above.
Press OK button under Single Point Measurement mode, you can switch
impedance and S-parameter measurements and capacitance and
inductance measurements.
To Next Page
Loading...