To Next PageTo Next PageHow to fix weighing pan error on A&D FZ-3000i Scales?
If the A&D Scales show a weighing pan error because the weight value is too light, confirm that the weighing pan is properly installed and calibrate the balance.
What does sample mass error mean on A&D Scales?
If the A&D Scales display a sample mass error, it means the balance can't store the sample for counting or percent mode because it's too light. Use a heavier sample.
How to resolve unit mass error on A&D FZ-3000i Scales?
If the A&D Scales display a unit mass error, it means the sample unit mass for the counting mode is too light. Add samples to reach the specified number and then press the PRINT key.
General| Capacity | 3200 g |
|---|---|
| Readability | 0.01 g |
| Calibration | External |
| Repeatability (Standard Deviation) | 0.01 g |
| Linearity | ±0.02 g |
| Operating Temperature | 5°C to 40°C |
| Interface | RS-232C |
| Power Supply | AC adapter (included) |
| Display | Vacuum Fluorescent Display |
| Stabilization Time | Approximately 1.5 seconds |
| Units | g, oz, lb, ct, dwt, GN, ozt, mom |
Overview of the manual's structure and content.
Highlights the key capabilities and design aspects of the balance.
Details compliance with FCC rules and CE mark directives.
Instructions for carefully unpacking the balance and checking contents.
Step-by-step guide for assembling the balance and its components.
Guidelines for installing the balance in an optimal environment.
Precautions and tips for accurate weighing and device care.
Instructions on how to properly clean and care for the balance after use.
Information regarding balance power supply and warm-up procedures.
Explains the various indicators and symbols shown on the balance display.
Lists and describes the various weighing units available on the balance.
Instructions on how to select and arrange units in the function table.
Step-by-step guide for performing basic weighing in gram mode.
Instructions for using the balance to count objects based on unit mass.
Guide to using the percent mode for target weighing or comparison.
How to perform statistical calculations on weighing data.
Instructions for calibrating the balance using its internal mass.
Guide to calibrating the balance using an external calibration weight.
Procedure to correct the internal mass value for improved accuracy.
Explains how to permit or inhibit access to balance functions.
Procedure to reset balance parameters to their factory settings.
Explains the two-layer structure (Class and Item) of the function table.
Details parameters for condition, stability band width, and hold function.
Configures data output performance for RS-232C serial interface.
Describes various data formats (A&D, DP, KF, MT, NU, CSV) for output.
How to set and confirm the balance's internal clock and calendar.
Using the balance to compare weights against upper and lower limits.
How to set an ID number for balance identification in reports.
Details on outputting GLP/GMP compliant reports for calibration data.
Explains settings for disabling, requesting, or restricting access via password.
Details limitations on weighing, calibration, and settings based on login level.
Covers transmission system, rate, data format, and D-Sub 9-pin assignments.
Explains how to connect and configure the AD-8127 and AD-8121B printers.
How to connect the balance to a personal computer via RS-232C or USB.
Guide to using WinCT software for balance communication and data analysis.
Lists commands for querying weight data and controlling the balance.
Explains acknowledge codes and error codes received from the balance.
Instructions on cleaning the balance main unit, breeze break, and weighing pan.
Guides to check balance performance, environment, and weighing methods.
Lists and explains various error codes displayed by the balance.
Details the USB interface for data transmission to a PC.
Explains the Ethernet interface for LAN connection and data management.
Describes the rechargeable battery unit for portable use.
