AAON CL SERIES User Manual

CL STARTUP FORM PAGE 1 of 2
DATE:___________________
JOB NAME:_________________________________________________________________________________________
ADDRESS:_________________________________________________________________
MODEL No:______________
CITY, STATE:______________________________________________________________
SERIAL No:______________
START-UP CONTRACTOR:___________________________________________________
TAG:____________________
PRE START-UP CHECKLIST
Installing contractor shall verify the following items (cross out items that do not apply).
1. Is there any visible shipping damage?__________________________________________________
Yes
No
2. Is the unit installation level?__________________________________________________________
Yes
No
3. Are the unit clearances adequate for service and operation?_________________________________
Yes
No
4. Do all access doors open freely and are the handles operational?_____________________________
Yes
No
5. Have all shipping braces been removed?________________________________________________
Yes
No
6. Have all electrical connections been tested for tightness?___________________________________
Yes
No
7. Does the electrical service correspond to the unit nameplate?________________________________
Yes
No
8. Has the overcurrent protection been installed to match unit nameplate requirement?______________
Yes
No
9. Have all set screws on fans been tightened?______________________________________________
Yes
No
10. Do all fans and pumps rotate freely?___________________________________________________
Yes
No
UNIT CONFIGURATION
AIR COOLED__________
EVAPORATIVE COOLED _____
NO WATER LEAKS ___
CONDENSER SAFETY CHECK_______
COOLING TEST
COMPRESSORS
CRANKCASE
NUMBER
MODEL #
AMPS
HEATER
L1 Volts/Amps
L2 Volts/Amps
L3 Volts/Amps
AMPS
1
2
3
4
5
6
7
8
AMBIENT TEMPERATURE
AMBIENT DRY BULB TEMP_______________°F
AMBIENT WET BULB TEMP_______________°F

AAON CL SERIES Specifications

General

Brand	AAON
Model	CL SERIES
Category	Heat Pump
Language	English