AAON-OE332-23P-VCMX-MOD-1A.doc Page 1 of 1
Description
The VCM-X Modular E-BUS Controller
(Orion Part No. OE332-23P-VCMX-
MOD-A; AAON Part No. VXXXXX) is a
drop in replacement for the OE332-
23E-VCMX-MOD-A; AAON Part
No.V07150. It is designed with 7
analog inputs, 2 analog outputs, and 5
relay outputs.
The Controller’s input and output ca-
pabilities can be expanded with the
VCM-X Expansion Module (OE333-23-
EM), 12 Relay Expansion Module
(OE358-23-12R), and 4 Binary Input
Expansion Module (OE356-01-BI) that
plug into the controller by means of a
modular cable and the E-BUS Modular
Expansion Modules such as the One &
Two Condenser Head Pressure
Modules and the Water Source Heat
Pump Modules.
The VCM-X Modular E-BUS Controller
can be configured for control of VAV
Units (with or without VAV/Zone
Controllers), Constant Volume Units,
and Make-Up Air Units.
The available Expansion Module con-
figurations allow for 8 additional binary
inputs, 4 additional analog inputs, 5
additional analog outputs, and up to 16
additional binary (relay) outputs.
Mounting
The VCM-X Modular E-BUS Controller is housed in a plastic enclosure. It is designed to be mounted by using the 3
mounting holes in the enclosure base. The VCM-X Modular E-BUS Controller needs to be installed in an environment
which can maintain a temperature range between -30°F and 150°F not to exceed 90% RH levels (Non-Condensing). It
is important to mount the controller in a location that is free from extreme high or low temperatures, moisture, dust, and
dirt. Be careful not to damage the electronic components when mounting the controller.
Technical Data OE332-23P-VCMX-MOD-A
VCM-X Modular E-BUS Controller
Operating
Power
24 VAC Power Consumption 8 VA Maximum
Operating Temp
-30F to 150F
Operating Humidity 90% RH Non-Condensing
Communications I
2
C Weight 1 lb.
Inputs 7 Analog Inputs Outputs 2 Analog Outputs
5 Relay Outputs
Three Year Warranty WattMaster reserves the right to change specifications without notice
OE332-23P-VCMX-MOD-
VCM-X Modular E-BUS Controller