To Next PageTo Next Page
Need help?Do you have a question about the AAON Pioneer Gold and is the answer not in the manual?
General| Brand | AAON |
|---|---|
| Model | Pioneer Gold |
| Category | Controller |
| Language | English |
Important safety instructions and warnings for handling electrical equipment.
Describes the systems and units the Pioneer Gold Controller is designed for.
Key guidelines for correct and safe electrical wiring practices.
Identification of various connection points and components on the controller.
Detailed diagrams and descriptions for various system harnesses.
Detailed explanation of the function for each controller input and output.
Operational logic for the supply fan based on room sensor input.
How the compressor operates under thermostat control.
Description of automatic reset alarms and their conditions.
Using controller LEDs to verify operation and diagnose issues.
Procedure for testing temperature sensors and their voltage/resistance.
Methods to improve RS-485 communication reliability.
Analog values and descriptions for BACnet® Legacy systems.
Analog values and descriptions for BACnet® MS/TP and IP.
Diagram and notes for establishing a ModBus RTU connection.
List of ModBus holding registers with their addresses and descriptions.
Introduction to the Prism 2 software interface and its features.
Details of the Pioneer Gold controller status screen and its displayed information.
How to access and modify controller setpoints within Prism 2.
Description of icons used for navigating main and settings screens.
Initial setup steps and overview of the main screen interface.
Procedure for accessing configuration screens via password entry.
Instructions for changing manager and administrator passcodes.
Procedure for setting the system time and configuring daylight savings.
How to configure daily, weekly, and holiday schedules for unit operation.
Selecting and setting various operational configurations for the controller.
Procedure for navigating and modifying setpoints via the touch screen.
Instructions for updating firmware and transferring setpoints via USB.
Setup and configuration of network protocols like ModBus, BACnet, and IP.
How to access and interpret the alarm status screen.
Procedure for using and configuring occupancy override on the touch sensor.
